DC Generators :: Online Mock Test-2 Free [Electrical Engineering Quizzes Series]

QC-SKILLS
By -
0
DC Generators Online Free Mock Test, Multiple Choice Questions and Answers on DC Generators, Electrical Engineering Quizzes, Electrical Student study,

DC Generators - Online Free Mock Test-2

Get online test series along with free mock tests for Electrical Engineering and other exams. 

Number of Questions - 40 MCQ's

Notes : The Quiz makes In multiple-choice quiz, there is a timer for 50 seconds/question.When 10 seconds is left, automatically the timer is red in color.finally, when the time is end,the correct answer is automatically shown.

>> CLICK HERE <<


Example Questions: 

  1. The number of armature parallel paths in a two-pole D.C. generator having duplex lap winding is
  2. The resistance of armature winding depends on
  3. For a D.C. generator when the number of poles and the number of armature conductors is fixed, then which winding will give the higher e.m.f.?
  4. If brushes of a D.C. generator are moved in order to bring these brushes in magnetic neutral axis, there will be
  5. In the case of lap winding resultant pitch is
  6. Two generators A and B have 6poles each. Generator A has wave wound armature while generator B has lap wound armature. The ratio of the induced e.m.f. is generator A and B will be
  7. In a D.C. generator in order to reduce sparking at brushes, the self-induced e.m.f. in the coil is neutralised by all of the following except
  8. The rapid wear of brushes takes place due to
  9. A 220 V D.C. generator is run at full speed without any excitation. The open circuit voltage will be
  10. The terminal voltage of a series generator is 150 V when the load current is 5 A. If the load current is increased to 10 A, the terminal voltage will be

Top 40 Typical Interview Questions and Answers for  DC Generators Electrical Engineering 
#sapid_welding, #aramco_cbt_Instrumentation_qc_inspector, #questions_answers_pdf_free, #Instrumentation_qc_notes, 
                    Take the Quiz

                    Post a Comment

                    0Comments

                    Post a Comment (0)